Catalytic converters- Dual bed and three way catalytic converters


Catalytic Converters 
Catalytic converter is a  way of treating exhaust gases. These convert harmful pollutants into harmless gases. A catalyst is a material that causes chemical change without entering into chemical reaction. In effect the catalyst encourages to react with each other. For
example, in the HC/CO catalytic converter, the catalyst encourage5 the HC to
unite with oxygen to produce

Comments

Post a Comment

Popular posts from this blog

Alignment Handout

Image
Factors Influencing Alignment procedure 1- Eccentricity (runout) Check · This might be done by a dial gauge 2- Baseplate of machines (soft-foot) · Machines feet must be mounted perfectly horizontal with the baseplate. · The contact between the baseplate and the feet can be checked with a set of shims or with feeler gages. · During a new installation, o it is essential to use accurate straight edges and levels to make sure that all feet of the machine are on the same plane. · The accepted tolerance level for these planes is usually 0.1 mm. · Simple tests for soft-foot are by setting up the dial gage (at fixed place) and place a shim under one front foot and the reading noted. · It is then removed and placed under the next front foot. The reading should be the same. · The same procedure must be repeated for the rear feet. 3- Axial position of machines · The axial position of shaft ends is referred to as the distance between shaft ends (DBSE). · Normally, most couplings allow a large tole...
Read more

CAT Engine Course(Part 4) Cooling System

Image
Cooling System COOLING SYSTEM SCHEMATIC This diagram shows the basic cooling system. We can use it to see the components of the system and see how they are connected. In the diagram, we see the engine block, cylinder heads (separate heads for each cylinder), coolant manifold, housing of the temperature regulators (thermostats), water outlets bypass line from regulator housing to water pump, water pump, water inlet from radiator or heat exchanger, coolant line to the aftercooler, and the oil cooler. 1. water pump 2. oil cooler 3. cylinder heads 4. water manifold (right side) 5. aftercooler 6. temperature regulator housing 7. bypass line from regulator housing to water pump. COOLING SYSTEM FLOW Coolant flow comes from the elbow which is connected to the radiator or other heat exchanger into the center of the water pump. The cooler flow is divided at the outlet of the water pump. One partflows to the aftercooler; the other part to the oil cooler. Coolant sent to the aftercooler goes throu...
Read more

Condenser Classification – De-aeration of Condenser

What is Condenser  ?  The primary purpose of the condenser is to condense the exhaust steam from the turbine and thus recover the high-quality feedwater for reuse in the cycle. In order for a steam power station to operate an efficient-closed cycle, the condensing plant, cooling water (CW) system, and associated pumps must extract the maximum quantity of heat from the exhaust steam of the
Read more